相关文章

我们需要了解的工业门导轨安装知识

来源网址:

金道尔教你安装工业门导轨

Jin Daoer teach industrial door installation guide

1.在工业门

的两侧确定好导轨安装位置,用锤线放出导轨基准线,导轨连接件固定螺栓十字线,导轨超过吊顶不能小于75cm.

1. In the industrial sure good guide rail is installed on both sides of the door, with hammer out guide rail line, guide fittings fixed bolt reticle, guide more than ceiling not less than 75 cm.

2.在用冲级钻在墙柱上打出连接件固定膨胀螺栓孔,上下固定几块连接件,将导轨帖上,校正垂直并点焊,导固定后再检查导轨的垂直度,每米不得大于5.5mm,全长垂直度不得超过21mm,负荷帘面嵌入导轨深度。

2. In the play the fittings with blunt class drill on the wall column fixed expansion bolt hole, fixed up and down a few fittings, guide post, correction and spot welding, the vertical guide check again after a fixed guide rail vertical degree, shall not be greater than 5.5 mm per metre, verticality shall not be more than 21 mm, load shade embedded depth of the guide rail.

3.将其余连接件装上,连接件与导轨之间采用电焊,每件连接件与导轨间不能少于6个电焊点,宽度不小于5.5mm,焊接处不能应穿现象发生。

3. Will the rest of the fittings installed, adopt welding between fitting with a guide rail, each connector between the guide rail and it may not be less than 6 electrical solder joints, the width is not less than 5.5 mm, welds should not wear phenomenon.

采用不锈钢导轨时焊条也必须采用不锈钢焊条。

4. Industrial door stainless steel rail electrode must also adopt stainless steel electrode.